- Store
- >
- Jeep JK and JKU
- >
- Suspension Components
- >
- Jeep JKU Rear Coilover Shock Tower Kit
Jeep JKU Rear Coilover Shock Tower Kit
Our shock towers for your Jeep JK and JKU are the strongest on the market. They're built from 3/16" high strength steel plate, precision cut, bent and welded to achieve ultimate strength and a beautiful design. This kit includes driver and passenger shock towers, lower shock mounts, a weld in shock tower cross member, as well as chassis reinforcement brackets and cap off plates.
These shock towers are designed to run a 2.0, 2.5 or 3.0 x 14" coilover shock. We spent countless hours designing these towers to keep your Jeeps ride height as low as possible while maximizing the suspensions up travel. Typically when compared to other Jeeps built in a similar manor, our set up can sit 2-3 inches lower on the over all ride height while still having the same amount of up travel. This means you can set your Jeep up lower, without compromising handling performance through rougher, faster terrain.
To make installation of the towers easy and add strength and durability to the kit, we used doubler plates on the chassis where the shock towers mount. These doublers distribute forces applied to the chassis from the suspension over a larger surface area. This makes for a much stronger mounting point as well as helping to prevent cracks from forming years down the road. These plates also include alignment holes that match up to existing factory holes on the chassis for easy and precise installation.
These towers require cutting a pocket in the frame rail to make room for the shock. Weve included chassis reinforcement brackets and cap off plates to strengthen the chassis after doing so. These parts are specifically designed to work with existing factory locations for easy and precise installation. By the time these brackets are welded in place, your chassis is stronger than when it came out of the factory.
These towers also come through the fender wells. We sell a sheet metal, weld in enclosure to close the tub back up. These are sold separately from the coil over kit.
Weve also included a weld in shock tower cross member to keep the shock towers stable under harsh conditions.
This kit requires a minimum of 72" WMS to WMS on your axle with a 3.5 backspaced wheels. You could also run a 74" wide axle with a 4.5 back spaced wheel and so on.
No, you can not run 12" coil overs with these towers. your axle will take out everything above it.
Pair this kit with our Front Coilover Shock Tower Kit, Front Long Arm Kit and Rear Long Arm Kit for the ultimate suspension system!!